Articles
NOTE: The PTZ camera remote control settings parameters must be consistent with the Camera Controller settings, otherwise the Camera Controller cannot control the PTZ camera. The addresses under different protocols can be the same or different, but under the VISCA protocol, PTZ camera address range: 1 to 7, under the Pelco-P/Pelco-D protocol, PTZ camera address...
1. Please check the hardware: RS485. Step 1: RS485 A and B is reversed. Step 2: Check RS485 cable continuity is OK or not. 2. Please check the software settings: keyboard controller and speed dome address, protocol, and baud rate. Step 1: Press [ Search ] to check the current protocol and baud rate is...
In any status, press setup till the system setting menu appear, reset the password.
