AI Tracking Guide for 1080P Version

There are two ways to enable the tracking:

1. Use the OSD menu to enable it. In the AI Mode column, press the left and right key on the remote control to switch between different modes. Currently, there are three tracking modes, auto framing, demo tracking, single tracking

2.  Toenabletracking with shortcut keys on remote control.

2.1 Auto framing

F1 to enable the auto framing, F4 to disable it.

2.2 Demo mode

F2 to enable demo mode, F4 to disable it. When it is enabled, the tracking target will be shown in the red wireframe if there are more than one people in the view. Left and right key for selecting   different tracking targets. When you selected the tracking target successfully, press home button to get it effective. The red wireframe will be there during the whole tracking. F4 to disable it.

2.3 Single mode

F3 to enable single mode, F4 to disable it. When it is enabled,the tracking target will be shown in the red wireframe if there are more than one people in the view. Left and right key for selecting different tracking targets. When you selected the tracking target successfully,     press home button to enable it. The red wireframe will be gone during the whole tracking. F4 to disable it.

3.   Notes

3.1

When the tracking target is lost, the camera will stay at the lost position for a few seconds and then return to the initial position. When the target appears again, it will automatically      identify and enter the tracking state.

3.2

When the camera is in the tracking state, you cannot directly press the shortcut key to switch the tracking mode. You need to press the F4 key to exit the current tracking mode first.